From 714942435c336bb136cda4d3f0fb64b570cb0164 Mon Sep 17 00:00:00 2001 From: Christophe Rhodes Date: Sat, 11 Jan 2014 16:34:17 +0000 Subject: [PATCH] update README for new slime location --- README | 33 +++++---------------------------- 1 file changed, 5 insertions(+), 28 deletions(-) diff --git a/README b/README index d7dc564..74c331b 100644 --- a/README +++ b/README @@ -23,14 +23,14 @@ * Installation ** Emacs configuration *** Installing SLIME - SLIME is required separately from swankr. To install slime, - perhaps the simplest is to pull the CVS sources into a + [[http://common-lisp.net/project/slime/][SLIME]] is required separately from swankr. To install slime, + perhaps the simplest is to pull the [[https://github.com/slime/slime][git sources]] into a user-specific site directory, and arrange for that to be on the - emacs =load-path=; I did + emacs =load-path=; something like the following: #+begin_src sh mkdir -p ~/.emacs.d/site-lisp cd ~/.emacs.d/site-lisp -cvs -z3 -d:pserver:anonymous:anonymous@common-lisp.net:/project/slime/cvsroot co slime +git clone https://github.com/slime/slime.git #+end_src Following that, I have in my =~/.emacs= (you will need to adjust @@ -49,6 +49,7 @@ cvs -z3 -d:pserver:anonymous:anonymous@common-lisp.net:/project/slime/cvsroot co (git-sbcl ("sh" "/home/csr21/src/lisp/sbcl/run-sbcl.sh" "--dynamic-space-size" "2048")) (R ("R" "--no-save" "--max-vsize=4096M") :init (lambda (port-filename coding-system) + (load "/home/csr21/src/R/swankr/swankr") (format "source('/home/csr21/src/R/swankr/swank.R', keep.source=TRUE, chdir=TRUE)\nstartSwank('%s')\n" port-filename))))) (global-set-key (kbd "s-s") 'slime-selector) @@ -79,30 +80,6 @@ cvs -z3 -d:pserver:anonymous:anonymous@common-lisp.net:/project/slime/cvsroot co RET= should start swank. You will be prompted to accept a version mismatch -- simply accept -- then the SLIME REPL should start up, giving a prompt. Enjoy! -** Proof-of-concept (OBSOLETE) - [ The instructions here are for the seriously impatient, and do not - give as good an experience ] - - To begin using swankr: - - 1. start R; - 2. load the swank.R file: -#+BEGIN_SRC R - source("swank.R") -#+END_SRC - 3. at the R prompt, run -#+BEGIN_SRC R - swank(); -#+END_SRC - 4. within emacs, load and initialize slime; -#+BEGIN_SRC emacs-lisp - (require 'slime) - (slime-setup '(slime-repl slime-presentations slime-media)) -#+END_SRC - 5. run =M-x slime-connect=, accepting the default host and port, - and acknowledging the protocol version mismatch. - - At this point, an R REPL should appear. * Development swankr's primary development repository is a git repository, accessible through -- 2.39.5